Smoke Systems
SS Z062

Fuel Sensor S for Up to 50cc and 100N Turbines

Fuel Sensor S for Up to 50cc and 100N Turbines

In Stock
$149.00
Item Qualifies for Free Ground Freight (48 States) on Orders Over $150

Fuel Sensor S for Up to 50cc and 100N Turbines, from Smoke Systems

With its measuring range of 20 - 150ml/min (in pressure lines up to 300ml/min) this sensor is suitable for combustion engines from approx. 50ccm and turbines up to approx. 100N. The fuel sensor is simply inserted into the fuel line and measures the flow in the fuel line. Gasoline and diesel/kerosene as well as methanol are possible fuels.

This telemetry sensor (for PowerBox P²BUS and Jeti EX-BUS) measures the fuel flow from the tank to the engine or to the turbine and can therefore reliably display the tank level.

Due to the measuring range, the sensor is suitable for combustion engines from approx. 50ccm and for turbines with a thrust of up to approx 100N.

Telemetry for CORE/ATOM and Jeti
The fuel sensor can be connected to the Jeti EX-BUS and the PowerBox P²BUS. The protocol used is automatically recognized by the sensor. The settings in the sensor are also made via the BUS. A separate programming device is not required. With the Jeti, the setting is made via the JetiBOX in the transmitter and with the PowerBox via the sensor menu.

Only a few settings need to be made.

Reset channel: The fuel gauge is reset manually after refueling via a freely selectable channel.

tank volume: The tank size is set here and saved in the sensor.

Reserve: This is the amount of fuel left in the tank when the alarm goes off.

The sensor is immediately ready for use. As soon as the fuel sensor is connected to the bus, it automatically adapts to the correct bus protocol.

The sensor supplies the following values:

  • Tank capacity in ml
  • tank content in %
  • Reserve volume in ml
  • flow in ml/min

The values shown are shown accordingly for Jeti.

  • Weight: 12g
  • Measuring Range: 20 – 150 ml/min in Suction Lines; 20 – 300 ml/min in Pressure Lines
  • Size: 40 x 20 x 20 mm (L x B x H)
  • Voltage: 6 – 12 Volt
  • Current: <= 20mA
  • Protocal: EX-Bus, P²-Bus