Phillips
OIL 100AW C

Phillips 66 Victory 100AW Single-grade Engine Oil, Qt, from Phillips, oil-100aw

Phillips 66 Victory 100AW Single-grade Engine Oil, Case

$77.00
$20.00 Flat Rate Ground Shipping (48 States)

Phillips 66 Victory 100AW Single-grade Engine Oil, Case

Ships from the East Coast Locations

ASHLESS DISPERSANT, SINGLE-GRADE ENGINE OIL WITH ANTIWEAR ADDITIVE FOR AIRCRAFT PISTON ENGINES

Phillips 66® Victory Aviation Oil 100AW is an ashless dispersant, single-grade engine oil pre-blended with the proper concentration of antiscuff/antiwear additive (LW-16702) mandated by Lycoming Service Bulletins 446E and 471B and Service Instruction 1409C. It is recommended for use in opposed piston and radial piston aircraft engines where cam lifter wear is a concern.

  • Ashless dispersant helps minimize engine sludge and varnish deposits for a cleaner engine
  • Pre-blended with Lycoming-approved antiwear additive
  • High film strength for protection against wear and piston scuffing
  • High viscosity index and low pour point for use over a wide temperature range
  • Protects against rust and corrosion
  • Formulated with the same high-quality base oils as used in Phillips 66 X/C® Aviation Oil

Applications: Opposed piston aircraft engines, especially where cam lifter wear is a concern

Victory Aviation Oil 100AW meets the requirements of:

  • Avco Lycoming Material Specification No. 301G
  • Pratt & Whitney Service Bulletin No. 1183 Rev. U
  • SAE Standard J1899
  • Teledyne Continental Material Specification MHS-24B
  • U.S. Military Specification MIL-L-22851D (obsolete) for additive treatment
  • SAE Grade: 50
  • Gravity, °API: 27
  • Specific Gravity @ 60°F: 0.893
  • Density, lbs/gal @ 60°F: 7.44
  • Color, ASTM D1500: 3
  • Flash Point (COC), °C (°F): 255 (491)
  • Pour Point, °C (°F): -27 (-17)
  • Viscosity, Kinematic:
  • cSt @ 40°C: 189
  • cSt @ 100°C: 19.5
  • Viscosity Index: 118
  • Acid Number, ASTM D664, mg KOH/g: 0.04
  • Ash Content, SAE J1787, wt %: 0.04
  • Copper Corrosion, ASTM D130: Pass
  • Foam Test, ASTM D892: Pass