Telemetry Adapter, for JetCat V10/V6 ECU Models

• The JetCat telemetry adapter connects directly to the ECU data bus.
• The output of the telemetry adapter is typically directly connected to the receiver (Telemetry input of the receiver).
• The adapter has two outputs connected in parallel so that another device or sensor can be connected to the 2nd port.
• The following values can be transferred depending on the system used:

• Exhaust gas temperature in ° C
• Turbines actual speed in 1/min
• Pump voltage in V
• Voltage of the turbine battery in V
• Current consumption in A. Only for ECU V10.0 or higher
• Battery capacity in mAh (Turbine battery). Only for turbines with generator function (for example P220RXi, P180-NX)
• Turbine state and error codes
• rest fuel in ml / rest fuel in%
• fuel flow in ml/min
• Altitude in meters. Only with ECU V10.0 or higher
• Thrust in N
• Turbines Set speed in 1/min
• Airspeed in km/h
• Speed of second shaft (propeller speed for turboprops or main rotor speed for helicopter engines)

Starting Telemetrie Adapter with firmware V. 9.0, the following systems are supported:

ATTENTION:

• ECU V5/6: LED I/O board 61108-0000 with 8-pin ERNI socket necessary
• ECU V10 LED I/O board Mini 61108-0050 necessary
• ECU V6 with firmware 6.42 or higher required