David Clark H10-13XP Electronic Noise Canceling Headset, Panel Powered

Panel Powered Electronic Noise Canceling

• For use with Permanent Panel Mount module - utilizes aircraft power supply
• Expanded, super-soft, double foam head pad
• Larger, yet lighter, Comfort Gel, undercut ear seals
• Coiled cord assembly connects to Permanent Panel-Mount Module - utilizes aircraft power supply
• Pilot selectable automatic Shut-Off feature
• Five-foot (extended) coil cord
• Dual volume controls let you adjust the listening level for each ear
• Exclusive, patented flex/wire boom for easy, precise microphone placement
• NRR - 23 dB passive noise reduction. Additional 17 - 22 dB low-frequency noise attenuation when ENC is activated
• Weight (without cord assembly): 22 oz.

• Earphone Type: Dynamic(ENC)
• Noise-Canceling Mic: M-7A Amplified Electret
• Earphone Impedance: Monaural, 150 Ohms nominal, stereo, 300 Ohms nominal per side
• Mic Impedance: 50 ohms +/- 20%
• Earphone Sensitivity: 90 dB SPL on flat plate coupler, re 1mW input @ 1KHz
• Mic Sensitivity: 400mV RMS ±6dB into 150 ohm load @ 1kHz for 114dB SPL input
• Earphone Frequency Response: 100-5,500 Hz
• Mic Freq Response: 300Hz--3.5KHz per RTCA DO 214
• Earphone Plug: PJ-055 (.25" phone plug)
• Mic Plug: PJ-068 (.206" phone plug)
• Boom Type: Patented Flex/Wire
• Cord: 5 ft.Straight
• Headpad/Hardware: Super-Soft, Double-Foam Headpad,Lightweight Hardware
• Weight/Headset Only: 18 oz.