33% Sukhoi 29 ARF Gas Airplane, by Krill Models
Click Here to Download Instruction Manual- Canopy and cowl are installed
- Landing gear ready to be attached
- Rudder servo tray glued in
- Bulkheads installed
- Fuel and smoke tank holders glued in
- Wings and servo bays installed
- Predrilled location for control horns an all surfaces
- Predrilled plates for different engines included
- Huge area in fuselage when canopy latch is removed
The way this plane is set up from our factory and staying within a recommended CG location, you will not need any mixing in knife edge or inverted!!! Snap roll are stopped immediately and very crisp!!
Parts description:
Fuselage: vacuum sandwich with all bulk heads installed, including c/f inside canopy frame
Wings: vacuum sandwich; aluminum wing tube 40mm, each panel needs 2 servos( JR 8711 recommended).
Elevators: vacuum sandwich; Can be taken apart if needed. Hinge wire is a brass tubing. Each half has one mount for servo. Two aluminum tubes 10/1mm.
Rudder: vacuum sandwich. Hinge wire is a brass tube, removable on the bottom, if rudder needs to be removed for transportation.
Canopy hatch: Made from Aluminum & titanium. Canopy frame is fitted on to fuselage from factory. Only two M4 screws and two wooden dowels are used.
Cowl: Fiber glass part. Fitted to the fuselage and attached using 8 M4 screws. Any 80 - 120ccm size engine will fit in without any problems.
Landing gear: aluminum, with all the holes predrilled. Wheel pants are fiber glass.
- Wingspan: 103" (2.62m)
- Length: 93" (2.36m)
- Flying Weight: 25.3 lbs (11.5 kg)
- Engine: 80-120cc
- Required: 9 channel radio & 5-10 servos
Secure Card Transactions
![]() |
Chief's Secure Ordering
Online Orders: | Our Site is Secure! |
Aircraft / Avionics Orders: | (800) 447-3408 |
Radio Control Orders: | (877) 219-4489 |
24 Hour Fax: | (541) 479-4431 |




Chief's Customer Service
Customer Service: (800) 447-3408