MPH83G Linear Hall Sensor Brushless Gyro Servo
- Unparalleled Linear Hall Sensor accuracy
- Exceptional performance with power sources from 4.8-8.5V
- Lower power consumption
- Ultra quiet operation
- Slow start function
- High-frequency digital amplifier
- Brushless motor powered
- Metal gears and heat sink case
- Dual ball bearing support
- JR 3-year limited warranty
The repetitive motion of a servo while in use places a large burden on each part. The recent development of brushless motors has increased the product life of servo motors dramatically. However, when determining servo position using existing potentiometers, long-period use causes wear inside the potentiometer parts so that smooth linear operation becomes impossible. To address this issue, JR has developed a new type of servo with non-contact position detection using Linear Hall ICs, which enable position detection using magnetic force. Using this technology, JR has now perfected its next generation MPH Series Linear Hall Sensing Servos.
A variety of receiver batteries are available on the model market. With certain batteries, the modeler must carefully choose appropriate servos or use a regulator between the battery and receiver; otherwise servos may be damaged due to a high voltage supply. Every WV servo has a micro computer to detect incoming voltage and automatically set the right voltage for the motor. Another sophisticated benefit of the new Wide Voltage servos is the Slow Start Function. When your system is switched on, instead of the servos instantly finding center as quickly as possible, Slow Start assures that on initial power up that the servo returns to the neutral position very slowly. The benefit is that you’ll see longer life from the internal servo gears and less wear and tear on the linkages of the control surfaces.
Where every the utmost accuracy is your aim, there is a JR Linear Hall Sensor servo to meet your needs. From the MPH83T that provides over 400 oz-in of power to your giant scale model, to the MPH83S that provides 0.007 sec/60º response speed to the cyclic control of your helicopter, you’ll enjoy performance that’s delivered at a lower power consumption rate, and operation that’s ultra quiet. And, because tail control is so important for helicopter pilots, there’s also the MPH83G Gyro servo, where Linear Hall Senor technology proves the ultimate benefit.
The motor used in this series of servos is a low-maintenance brushless motor that ensures long life and near instantaneous response. You’ll feel the difference the moment you take off on your first flight.
- Size Category: Standard
- Type: Digital
- Application: High-precision airplanes and helicopters
- Torque: 37.5 oz-in (2.7 kg-cm) @ 4.8V; 58.3 oz-in (4.2 kg-cm) @ 7.4V
- Speed: 0.07 sec/60 deg @ 4.8V; 0.05 sec/60 deg @ 7.4V
- Length: 1.60 in (40.5mm)
- Width: 0.83 in (21mm)
- Height: 1.44 in (36.5mm)
- Weight: 2.26 oz (64 g)
- Bushing Or Bearing: Bearing
- Bearing: Dual
- Gear Type: Nylon
- Voltage: 4.8 - 7.4V