EI AL1 Individual Annunciator Light

Annunciator light and electronics. When mounted in front of the pilot, bright red LED give a quick warning of an out-of-limit condition without having to scan the instrument panel. The unit can be connected to any EI Instruments featuring a warning light ( US-8A or SR08A, C-1P, FP-5, R-1, M-1, and OPT-1, etc.) Mounts in a 3/8" hole. Operates from 12 or 24 Vdc.

EI ATG1 Annunciator Tone Generator

Generates 4.7kHz tone when an out of limit occurs. The Annunciator Tone Generator may be connected to one or more EI Instruments featuring a waring light (US-8A or SR-8A, C-1P, EC-1P, T-1P, FP-5, R-1, M-1, and OPT-1, etc.) Comes with an on/off toggle switch. Mounts under the instrument panel using wire ties. Operates from 12 or 24 Vdc.

EI AV17 Voice Annunciator

The Voice Annunciator (AV17) can provide from one to seventeen verbal warnings throuh your headset, ending the need to continuously scan instruments. It also eliminates concern about missing an alarm at a critical moment. The instant a monitored alarm occurs, the Voice Annuciator will chime in the ehadset and a pleasant female voice will announce a phrase such as: " Check Oil Pressure", "Check Altitude", Etc. providing an instant and clear understanding of the problem at hand.

The AV17 connects to the headset through the audio panel or intercom, or may be directly connected to the ehadset. It receives most of its waring signals from any one or more of Ilectronics Internationsl's instruments which feature a warning light; however, other alarm signals can be received from any warning device that drives a horn or light. It is not necessary to activate all seventeen of the AV17's warnings. A"Check Bus Voltage" warning is built into each AV17. Further voice alarms may be activatd as EI instruments are added to the panel.

A 4.1" x 2.6" x 1.7" control box tie wraps under the instrument panel. Small 1" x 1" control panel mounts on the instrument panel and allows you to turn the Voice Annunciator on/off or acknowledge the warning and deactivate any active alarm for 1 or 10 minutes. The voice alarms are activated by pulling the apprpriate control line to ground potential.

Warnings: (Oil Pressure and Temperature, (2) Fuel Level and Pressure, (3) RPM, (4) Manifold Pressure, (5) Altitude and Timer, (6) Cylinder Head Temperature, (7) Exhaust Gas Tmperature, (8) Turbine Inlet Temperature, (9) Engine Analyzer, (10) Bus Voltage, (11) Gyro Vacuum, (12) Landing Gear, (13) Air Speed, (14) Oil Pressure, (15) Fuel Level, (16) Fuel Level, (17) Timer, (18) Chime Only, No Voice.