VIEW SHOPPING CART | TRACKING | CONTACT US | POLICY | FREE CATALOG  

ACE: Absolute Cost Efficiency

Available for Ground Shipping Only (48 States)

Upgrade from ACK Two-Frequency ELTs to 406 Mhz Technology

Part No.PHOTODescriptionCARTPrice
ATX 455-6614
 PHOTO 
 ELT, ME406 ACE, Artex
 ADD 
 $1148.00  
  • No alterations of instrument panel necessary for remote switch
  • Re-use existing wiring harness from remote switch to ELT
  • Mounting holes on Artex ME406 line up with existing holes for ACK ELT
  • Extremely simplified installation for maximum cost efficiency
  • Based on popular Artex ME406 system

Artex is proud to introduce ELT ME406 ACE. The ME406 ACE (for "Absolute Cost Efficiency") provides a simple and in-expensive upgrade solution from 121.5 MHz ACK and Ameri-King systems to the new Artex 406 MHz ELT technology. No alterations requirements for remote switch cut-out on instrument panel, re-usability of existing wiring harness and mounting holes of the Artex mounting tray lining up with the ACK ELT allow for extremely simplified installation for maximum cost reduction.

Top of page

ME-406 Emergency Locator Transmitter

Available for Ground Shipping Only (48 States)

Part No.PHOTODescriptionCARTPrice
ATX 455-6605
 PHOTO 
 ELT, ME406 with 110-773 Whip Antenna, Artex
 ADD 
 $935.00  
ATX 455-6607   ELT, ME406 with 110-338 Rod Antenna, Artex
 ADD 
 $1528.00  

Artex ME406 ELT Features:

  • Immediate search and rescue response
  • Position accuracy within 3 km
  • Transmitter is identified by serial number or aircraft ID
  • Worldwide coverage
  • 5-year battery life LiSO2/ LiMnO2
  • TSO-C126,ETSO-2C126 pending, COSPAS/SARSAT approved
  • Mounting holes compatible with most existing ELT housings
  • Single antenna output for both frequencies.
  • Designed especially for the private pilot.
  • 20 years of ELT design experience results in a breakthrough in design
  • A low cost solution to 406Mhz technology requirements
  • 121.5 and 406 MHz
  • ELT weight: 2 lbs.

The Artex ME-406 is a single output ELT. Two emergency frequencies (121.5 and 406.028 MHz) utilize the same RF output, which requires only one coax cable to connect to the new series of Artex single input antennas. The ELT automatically activates during a crash and transmits the standard swept tone on 121.5 MHz.

Every 50 seconds for 440 milliseconds the 406 MHz transmitter turns on and transmits an encoded digital message to the Cospas/Sarsat satellite system. The mounting hardware for the ME-406 Series is compatible with all previous models of Artex 406 MHz, as well as the ELT200 Series, Pointer Model 300 ELT and Narco ELT's.

Specifications:

Operating Frequencies:
406 MHz +- 1 kHz Biphase L (16K0GID)
121.5 MHz +- 0.005% (A3X)

Output Power:
406 MHz: 5 W (440 ms/ 50 sec) for 24 hours @ -20ºC to +55ºC
121.5 MHz: 100 mW min for 50 hours @ -20ºC to +55ºC

Output Connector: BNC Female

Activation: Automatic by 4.5 ft/sec G-Switch or Manual

Battery: 5 year Lithium (LiSo2, LiMnO2)

Temperature:
Operating: -20ºC to +55ºC
Storage: -55ºC to +85ºC

Self Test:
G-Switch enabled
406 MHz Power
121.5 MHz Power
Anenna/Coax Connection
Low Battery

Remote Control: ON/ARM/RESET

Antenna:
Rod (110-338) (<350 KTS)
Whip (110-773) (<200 KTS)

Weights: ELT Transmitter: 1.85 lbs (833 g)
Mounting Tray: 3.52 oz (100 g)
Total Weight: 2.05 lbs (933 g)

Measurements: ELT Transmitter with Mounting Hardware Installed:
6.59" (167 mm) L x 2.86" (73 mm) H x 3.69" (94 mm) W

Top of page

G406-4 406 MHz Emergency Locator Transmitter

Part No.PHOTODescriptionCARTPrice
ATX 455-5044
 PHOTO 
 ELT, Artex G406-4 Dual Output, Artex
 ADD 
 $1750.00  

The Artex G406-4 Emergency Locator Transmitter transmits on all 3 emergency frequencies (121.5/243.0 and 406 MHz). The ELT automatically activates during a crash and transmits the standard swept tone on 121.5 and 243.0 MHz. The G406-4 also transmits a 406.025 MHz encoded digital message to the Cospas/Sarsat satellite system, which allows for rapid identification and reduces Search and Rescue response time. The G406-4 has been tested to meet the rigorous requirements of TSO C126 including 500 G shock, 1000 pound crush as well as flame and vibration test. The G406-4 is available for use with Artex's low cost whip antennas or a sturdy fiberglass rod antenna. The G406-4 also may be interfaced with the Artex ELT/NAV Interface which enables latitude and longitude data to be transmitted as part of the 406.025 MHz message. The system includes the following: ELT Transmitter, 5-year Lithium Battery Pack, Mounting Bracket, Remote Switch, Coax Cables, 121.5 & 243.0 MHz Whip Antenna, 406.025 MHz whip antenna, Buzzer, Installation Hardware and Installation and Operations Manual. The antenna system is approved for aircraft operating at speeds up to 300 Knots.

(Type AF ELT) Cospas/Sarsat Approved, FAA TSO C126 Approved, JTSO-2C126 Approved

Specifications:

Operating Frequencies:
406.025 MHz +- 2 kHz Biphase L (16KOG1D) 121.5 & 243.0 MHz +- 0.005% (A3X)

Output Power:
406 MHz: 5W +- 2 dB for 24 hours @ -20º C
121.5/243.0 MHz: 100mW min for 50 hours @ -20ºC

Output Connector: BNC Female (121.5/243 MHz) TPS Female (406 MHz)

Activation: Automatic by 4.5 ft/sec G-Switch or Manual

Battery: 4 year Lithium (LiSO2) TSO C142 Approved

Weights: ELT Transmitter: 3 LB 5.8 oz Max (1.53 Kg)

Measurements: ELT Transmitter with Mounting Hardware Installed: 11.74"l x 3.90"h x 3.82"w

Top of page

ELT to NAV Interface

Part No.PHOTODescriptionCARTPrice
ATX 455-6500   ELT to NAV Interface, Artex
 ADD 
 $1575.00  

This ELT to NAV Interface is designed to be connected between the aircraft's Flight Management Computer (FMC) or GPS receiver and Artex's G406 series of ELTs. This unit will, upon activation, allows the ELT to transit the Latitude and Longitude of the aircraft to the COSPAS/SARSAT Satellite System. The interface also has the option of being able to program the ELT with the "Mode-S 24 Bit ID" of the aircraft.

COSPAS/SARSAT, FAA TSO C126 & JTSO-2C126 Approved

Top of page