VIEW SHOPPING CART | TRACKING | CONTACT US | POLICY | FREE CATALOG  

CT-415 Gap Setting Tool

Part No.PHOTODescriptionCARTPrice
CH CT415AV Gap Setting Tool with Gauge, Champion $113.50  

A low-cost efficient gap setting tool for close gaps on massive electrode type aviation spark plugs. Designed for use as a hand tool, for mounting on a bench, or to be held in a vise. Complete with one adapter for 18mm spark plugs only and one CT-450 gap gauge. Approximately 7 1/2" high.

Shipping Weight 2 Lbs.

ATS Plug Gapper

Part No.PHOTODescriptionCARTPrice
ATS 116 Spark Plug Gapper, Aircraft Tool Supply $11.95  

Sure Gap is designed to set the electrode gap on all massive electrode aircraft spark plugs. Saves time & money, eliminates guessing of plug gap.

Spark Plug Tray

Part No.PHOTODescriptionCARTPrice
ATS T240 Spark Plug Tray, Aircraft Tool Supply $46.95  
FT 12 Spark Plug Tray $21.95  
CH 93557 Spark Plug Tray, Yellow, Champion $37.50  
CH CT446 Spark Plug Tray, Red, Champion $47.50  

Sturdy steel spark plug tray holds up to 12 aviation spark plugs. Speeds handling of used or new plugs. Holes numbered to correspond with engine cylinders. Protects against shielding barrel contamination. Rubber, non-slip pads.

CT-450 Gap Gauge

Part No.PHOTODescriptionCARTPrice
CH CT450 Spark Plug Gap Gauge, Champion $21.50  
CH CT450-WG Replacement tips for spark plug gap gauge, set of 4 , Champion $8.50  

Metal case contains 2 sets of accurate retractable go and no go wire gap gauges:

Two sets: .015-.019


ATS Spark Gap Gauge

Part No.PHOTODescriptionCARTPrice
ATS 450 Spark Gap Gauge, Aircraft Tool Supply $13.95  

Wire gauge sizes (ATS 165): .015, .018, .020, .022, .028, .030.

Wire gauge sizes (ATS 450): .015, .018, .019, .022.


Spark Erosion Gauge

Part No.PHOTODescriptionCARTPrice
CH CT482 Erosion Gauge, Champion $5.50  

Champion CT-482 spark plug erosion gauge provides an easy, accurate method of determining whether your plugs have reached their maximum wear limit. Simply recap the used plug to .016 nominal, then attempt to insert the electrode assembly through the chamfered hole in the gauge, as shown. Penetration of the hole by the electrode assembly indicates the plug has exceeded its recommended wear limits and should be replaced. The CT-482 is calibrated to reject plugs after their electrodes have eroded to at least one-half their original thickness. Although aviation spark plugs will continue to fire past this wear point, the rate of electrode erosion will increase as a result of non-parallel gaps and reduced sparking area. This leads to intermittent misfire, increased ignition system wear, and possibly costly unscheduled maintenance.

CT-457 Fine Wire Gap Gauge

Part No.PHOTODescriptionCARTPrice
CH CT457 Sparkplug Fine Wire Gap Gauge, Champion $32.50  

Designed exclusively for adjusting fine wire electrode spark plug gaps.

Lead-Master Wrenches

Part No.PHOTODescriptionCARTPrice
CH CT911 Spark Plug Wrench 3/4, Champion
1.9 cm T handle open box wrench
$89.50  
CH CT912 Spark Plug Wrench 7/8, Champion
2.2 cm T handle open box wrench
$87.60  

Lead-Master wrenches reduce time to remove and install spark plug ignition leads, also permit short arc turning due to 12-point grip head.

double open box wrench for removing plug leads.

Spark Plug Sockets

Part No.PHOTODescriptionCARTPrice
CH CT907 Spark Plug Socket, Magnetic 7/8 inch hex 3/8 inch drive, Champion $55.50  
ATS 950 Spark Plug Socket, 3/8 inch Drive, Magnetic, Aircraft Tool Supply $21.95  
ATS T557 Spark Plug Socket, 3/8 inch Drive, Aircraft Tool Supply $31.95  

Sparkplug socket, 7/8" hex 3/8" drive

Spark Plug Cleaner

Part No.PHOTODescriptionCARTPrice
ATS 12 Spark Plug Cleaner, Aircraft Tool Supply
Cleans any size plug without changing grommet. 2-way valve. Comes complete with abrasive powder. 2 lbs.
$24.95  
ATS SAND Sand, for Spark Plug Cleaner, Aircraft Tool Supply $3.95  

ATS Spark Plug Vibrator Cleaner

Part No.PHOTODescriptionCARTPrice
ATS PA01 Spark Plug Vibrator Cleaner, Aircraft Tool Supply $29.95  
ATS PA01-1   Replacement Blade, for Spark Plug Vibrator Cleaner, Aircraft Tool Supply $6.95  

If you clean a lot of spark plugs, then you know that a spark plug vibrator cleaner is the only way to remove stubborn lead deposits. This tool will do the same job as the more expensive vibrator cleaners at a fraction of the cost. It will clean heavy deposits in and around the electrodes with absolutely no risk of damage to the plug.

Spark Plug Cleaner and Tester

Part No.PHOTODescriptionCARTPrice
CH 83-4-007-01 Spark Plug Cleaner/Tester, Champion $1750.00  

Designed to clean and test all massive and fine wire aviation sparklugs. Rubber adapters hangle 14 and 18 mm plug types. "Solid state" ignition system produces a very stable ignition test voltage allowing greater accuracy and reliability. Cleaning is by a dry-abrasive air blast. Built-in automatic water trap stops harmful airline moisture. Requires 125-180 PSI 15 pounds.

ATS Spark Plug Cleaner and Tester

Part No.PHOTODescriptionCARTPrice
ATS SPCT100 Spark Plug Cleaner/Tester, (115 volts), Aircraft Tool Supply $479.00  

ATS's Spark Plug Cleaner & Tester features the latest developments in spark plug service equipment. It's smart, functional styling combined with rugged construction makes it the perfect choice for anyone who needs to reliably and accurately check the quality of used spark plugs. The cleaner section uses a powerful blast of air and abrasive to thoroughly remove carbon deposits from plugs. The recessed observation mirror is perfectly angled to display the electrodes of the spark plug so that you can clearly judge the quality of the sprk as the plug is being tested. It is manufactured to the rigorous TSO 9002 standard and carries a full one-year factory warranty. Includes adapters for 12mm, 14mm, and 18mm plugs. Works with Aviation and Automotive plugs. Features a motorized turntable for automatic, "hands-off" cleaning of plugs. Test plugs at 15,000 volts and up to 150 psi to simulate engine conditions.

Eastern Technologies

E5 High-Voltage Cable Tester

Part No.PHOTODescriptionCARTPrice
EE E5 High-Voltage Cable Tester, Eastern Technologies $77.95  

Eastern Technology's Model E5 High Voltage Cable Tester tests Hi-Voltage aircraft engine ignition cables quickly and accurately. And it's incredibly easy to use: simply connect the three wires, push the test button and check the test window. That's all there is to it. By simulating the magneto's high output voltage, the E5 instantly identifies both good and defective cables. And it operates on either 12 or 24 volts, D.C.

The E5 eliminates guess work, saves valuable time, is equipped with an audio high voltage time, is equipped with an audio high voltage indicator to ensure safety and is 100% dependable. And no other high quality cable tester is as attractively priced.

Features:
  • Compact 3 in. x 5 in. x 2 5/8 in.
  • Weight 1 1/2 lbs
  • Heavy Duty Unbreakable Case
  • Heavy Scratch Resistant Aluminum Face Plate
  • Fail Safe Circuitry
  • Heavy Duty 18 Gauge Gas and Oil Resistant Lead Wires
  • Loud Audio Signal High Voltage Indicator
  • Complete Instructions with Each Unit

ATS Spark Plug Thread Chaser

Part No.PHOTODescriptionCARTPrice
ATS 20200 Spark Plug Thread Chaser, Aircraft Tool Supply $8.50  

Spark Plug Thread Chaser cleans threads in spark plug hole of dirt, carbon build-up, and metal particles. Double ended for both 14mm and 18mm threads. Neoprene band on hex drive holds tool securely in any 13/16" deep-well spark plug socket.